Model:GN30-12
Gn30-12 rotary indoor high voltage disconnector is a new type of rotary knife contact disconnector. Its main structure is to fix two sets of insulators and contacts on the upper and lower planes of the three-phase common low frame, and rotate the knife contact. So as to realize the closing and opening of the switch.
Model:HRH-B/33F-630-25kA
Pole-mounted Disconnector Switch 33KV is an electrical device for the reliable disconnection of certain sections of a high-voltage electrical network when there is no current in them. The use of isolating switches (either alone or in combination with high-speed short-circuiting devices) makes it possible to simplify the arrangement of switching points and transformer substations and to eliminate expensive high-voltage circuit breakers.
In the case of damage to certain sections of a network, the circuit breakers operate first, and then the isolating switches automatically disconnect the damaged section, after which the circuit breakers close again and restore electric power to the rest of the consumers on the network. Isolating switch......
Model:JBC
JBC Low voltage insulation piercing connector cable connector wire connector is suitable for aluminum and copper conductors and components not losable, end cap attached to body, Insulation material made of weather resistant glass fiber reinforced polymer, contact teeth made of tinned brass or copper or aluminum, bolt made of dacromet steel. When tightening the bolts, the teeth of the contact plates penetrate the insulation and establish a perfect contact. The bolts are tightened until the heads shear off. Stripping of insulation is avoided.
Model:GTL Al/Cu Bimetallic Compression Terminal Joint
GTL Type aluminum Copper Bi- Metallic splice are used for non-tension joining Aluminum Cable to Copper Cable.
Model:CW32L
CW Type Brass Cable Gland for use with steel wire armoured cables. Used to provide clamping of the armour wire to ensure electrical continuity and mechanical retention of the cable. The CW type brass cable gland is used for outdoor applications and where necessary to provide an IP66 seal with the outer sheath of the cable.
Model:SM4-150
Low Voltage Overhead Network Insulation Piercing Connector is suitable for aluminum and copper conductors and components not losable, end cap attached to body, Insulation material made of weather resistant glass fiber reinforced polymer, contact teeth made of tinned brass or copper or aluminum, bolt made of dacromet steel. When tightening the bolts, the teeth of the contact plates penetrate the insulation and establish a perfect contact. The bolts are tightened until the heads shear off. Stripping of insulation is avoided.
Model:JDC-01
JDC-01 High Voltage Surge Arrester Thermal Explode Typel explode type disconnector is a device for disconnecting an arrester from the system in the event of arrester failure, to prevent a persistent fault on the system and to give visible indication of the failed arrester. The thermal explode disconnectors meet the standard of IEC60099-4.